SN74HC574PWR Overview

The item is packaged in 20-TSSOP (0.173, 4.40mm Width)cases. You can find it in the Tape & Reel (TR)package. Currently, the output is configured to use Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. Surface Mountis in the way of this electric part. A 2V~6Vsupply voltage is required for it to operate. Currently, the operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. The 74HCseries comprises this type of FPGA. This D flip flop should not have a frequency greater than 40MHz. In total, it contains 1 elements. 20terminations have occurred. The object belongs to the 74HC574 family. A voltage of 5V is used to power it. Input capacitance of this device is 3pF farads. In this case, the D flip flop belongs to the HC/UHfamily. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. This device has the clock edge trigger type of Positive Edge. This part is included in FF/Latches. 8bits are used in its design. It reaches the maximum supply voltage (Vsup) at 6V. Normally, the supply voltage (Vsup) should be kept above 2V. This D flip flop is well suited for TR based on its reliable performance. A power supply of 2/6Vis required to operate it. This D flip flop is equipped with 0 ports. High efficiency requires the supply voltage to be maintained at 5V. The 7.8mA output current allows it to be designed with the greatest amount of flexibility. A total of 3input lines have been provided. There is 8μA quiescent current consumption by it. Currently, there are 8 channels available.

SN74HC574PWR Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC574PWR Applications

There are a lot of Texas Instruments SN74HC574PWR Flip Flops applications.

• Latch
• ATE
• Data storage
• Synchronous counter
• Bounce elimination switch
• Set-reset capability
• Shift Registers
• Buffered Clock
• Digital electronics systems
• Divide a clock signal by 2 or 4