SN74HCT374ANSR Overview

20-SOIC (0.209, 5.30mm Width)is the way it is packaged. The package Cut Tape (CT)contains it. As configured, the output uses Tri-State, Non-Inverted. It is configured with the trigger Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. The operating temperature is -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. JK flip flop is a part of the 74HCTseries of FPGAs. Its output frequency should not exceed 40MHz Hz. D latch consists of 1 elements. T flip flop consumes 8μA quiescent energy. The object belongs to the 74HCT374 family. The input capacitance of this JK flip flopis 3pF farads. The electronic part is mounted in the way of Surface Mount. A total of 20pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge.

SN74HCT374ANSR Features

Cut Tape (CT) package
74HCT series
20 pins

SN74HCT374ANSR Applications

There are a lot of Texas Instruments SN74HCT374ANSR Flip Flops applications.

• Storage Registers
• CMOS Process
• Set-reset capability
• QML qualified product
• Computing
• Shift registers
• Convert a momentary switch to a toggle switch
• Safety Clamp
• Functionally equivalent to the MC10/100EL29
• Frequency division