SN74HCT377DWRE4 Overview
As a result, it is packaged as SOIC. The package Tape & Reel (TR)contains it. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The power supply voltage is 5V. It is a member of the HCTfamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. Its clock edge trigger type is Positive Edge. The part is included in FF/Latches. The flip flop is designed with 8bits. The superior flexibility of this product is achieved by using 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. There are 5V power supplies attached to it. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It is designed with 1 output lines. It is reported that there are 3 input lines. WITH HOLD MODEis also one of its characteristics. High level output current is set to -4mA. Low level output current is set to 4mA. A temperature below 85°Cshould be used for operation. Ideally, the operating temperature should be greater than -40°C. The minimal supply voltage is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. It is possible to achieve a frequency of 37MHz. It adopts a logic IC of type D FLIP-FLOP. The T flip flop is equipped with 1functions . The JK flip flop has a pin count of 20.
SN74HCT377DWRE4 Features
Tape & Reel (TR) package
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74HCT377DWRE4 Applications
There are a lot of Texas Instruments
SN74HCT377DWRE4 Flip Flops applications.
- Computers
- Communications
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
