This electronic part is conveniently packaged in 16-SSOP (0.209, 5.30mm Width), making it easy to ship abroad. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 4:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 16. A 2 channel electronic part produces high-quality output. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. Electronic part bodies are injected with 16 pins. Unlike digital switches, these are based on SP4T switching circuits. The multiplexer consists of 2 circuits. Try searching for the analog switch ic with 74LV4052 if you are looking for variants. Internally, this switch multiplexer has a resistance of 100Ohm. To find out what the 16 pins do, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended that the electrical component receives a voltage of 2V. An operating current of 20μA would be sufficient for this switch device. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. Operating 8 inputs is required. The data can be transferred over a wide range of bandwidths, called 50MHz bandwidths. Its conductivity is 4-bit.