The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. High reliability is provided by advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 4:1 is the ratio between multiplexers and demultiplexers. Operating temperature extended to -40°C~85°C TA. Total terminations are 16. Due to its 2 channels, the electrical component produces high-quality output. If the voltage supply is 2.5V volts, the electrical component should be turned on and run. Electronic part bodies are injected with 16 pins. Circuits based on SP4T switching are used to construct these analog switch ics. This multiplexer is composed of 2 circuits. Look for analog switch ic variants by searching with 74LV4052. In this multiplexer, the internal resistance is 100Ohm. You can find the functions of the 16 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. The digital multiplexer has a low cost Single supply. It is recommended that the electrical component receives a voltage of 2V. 20μA current would be enough for this multiplexer to operate. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. It is integrated with DIFFERENTIAL MULTIPLEXER analog ICs. This analog switch ic utilizes SEPARATE OUTPUT output. A 8 input needs to be operated. It is possible to transfer data over a 50MHz-bandwidth. It conducts in a 4-bit manner.