SN74LV4066ADGVR Overview

As the electronic part is packed in 14-TFSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 14. The electronic part provides high-quality output because it has 4 channels. Powered by a 2.3V voltage supply, the electrical part should be switched on and run. The electrical component body receives 14 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with 74LV4066 to find analog multiplexer variants. An switch multiplexer with 75Ohm internal resistance has a value of 75Ohm. Datasheets for 14 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2V. An operating current of 20μA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 2V~5.5V volts. When the digital multiplexer is charged above 20μA, damage can occur. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. There are 50MHz bandwidths for data transfer.

SN74LV4066ADGVR Features

4 Channels
Switch Circuit: SPST - NO
20μA Supply Current
Bandwidth: 50MHz

SN74LV4066ADGVR Applications

There are a lot of Texas Instruments
SN74LV4066ADGVR Analog Switches & Multiplexers ICs applications.

• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement