SN74LVC2G53DCUT Overview

The electrical component comes in 8-VFSOP (0.091, 2.30mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 8 terminations have occurred. A electrical component with 2 channels is capable of high-quality output. When the electronic component is given a voltage of 2.3V, it should be turned on and run. Into the electrical component body are injected 8 pins. On the other hand, analog switches can be constructed using SPDT switching circuits. Circuits number 1 make up this analogue multiplexer. Look for analog switch ic variants by searching with 74LVC2G53. A 13Ohm internal resistance characterizes this multiplexer. The datasheets for the 8 pins explain the functions. The analog multiplexer shown here is a typical Multiplexers or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 1.65V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1μA current. Analogue multiplexers require a 1.65V~5.5V voltage to drain from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to use COMMON OUTPUT outputs on this digital multiplexer. Among the inputs that can be operated are the 2 inputs. It is possible to transfer data over a 300MHz-bandwidth.

SN74LVC2G53DCUT Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 300MHz
Bandwidth: 300MHz

SN74LVC2G53DCUT Applications

There are a lot of Texas Instruments
SN74LVC2G53DCUT Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)