SN74LVC574ADBRE4 Overview
The package is in the form of SSOP. As part of the package Tape and Reel, it is embedded. 20terminations have occurred. It is powered by a voltage of 1.8V . A device of this type belongs to the family of LVC/LCX/Z. It is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. An electronic part with 8bits has been designed. In order to achieve its superior flexibility, 8 circuits are used. The flip flop contains 2ports. There are no output lines on the JK flip flop. 3input lines are available for you to choose from. A high level output current of -24mAis set. In the low level output current setting, the current is set to 24mA. Ideally, the operating temperature should be below 125°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 1.65Vis required. A maximum voltage of 3.6V can be provided by it. This frequency can be achieved at 150MHz. There is a logic IC BUS DRIVER used in the D flip flop. It has 1 functions. 20pins are available on this JK flip flop. With an output current of 24mA, this flip flop offers maximum design flexibility.
SN74LVC574ADBRE4 Features
Tape and Reel package
20 pins
8 Bits
1 Functions
20 pin count
SN74LVC574ADBRE4 Applications
There are a lot of Texas Instruments
SN74LVC574ADBRE4 Flip Flops applications.
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
