TC7W74FKTE85LF Overview
The flip flop is packaged in SSOP. Package Cut Tape (CT)embeds it. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 8pins on it. This device has Positive Edgeas its clock edge trigger type. In terms of quiescent current, it consumes 2μA . -5.2mA is set as the high level output current. In the low level output current setting, 5.2mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 6V. It is possible to achieve 67MHz frequencies.
TC7W74FKTE85LF Features
Cut Tape (CT) package
8 pins
TC7W74FKTE85LF Applications
There are a lot of Toshiba
TC7W74FKTE85LF Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
