SN74LVC74ADRE4 Overview

The item is packaged in 14-SOIC (0.154, 3.90mm Width)cases. There is an embedded version in the package Tape & Reel (TR). Currently, the output is configured to use Differential. It is configured with a trigger that uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. It operates with a supply voltage of 1.65V~3.6V. It is at -40°C~125°C TAdegrees Celsius that the system is operating. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74LVCseries FPGA. Its output frequency should not exceed 100MHz. As a result, it consumes 10μA of quiescent current without being affected by external factors. A total of 14 terminations have been made. This D latch belongs to the family of 74LVC74. The power source is powered by 1.8V. JK flip flop input capacitance is 5pF farads. The electronic device belongs to the LVC/LCX/Zfamily. It is mounted in the way of Surface Mount. With its 14pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. It is included in FF/Latch. In this case, the maximum supply voltage (Vsup) reaches 3.6V. 2 circuits are used to achieve its superior flexibility. On the basis of its reliable performance, this D flip flop is well suited for use with TR. A total of 3.3V power supplies are needed to run it. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. There are 1 output lines in this JK flip flop.

SN74LVC74ADRE4 Features

Tape & Reel (TR) package
74LVC series
14 pins
3.3V power supplies

SN74LVC74ADRE4 Applications

There are a lot of Texas Instruments SN74LVC74ADRE4 Flip Flops applications.

• Test & Measurement
• Automotive
• Convert a momentary switch to a toggle switch
• 2 – Bit synchronous counter
• Power down protection
• Set-reset capability
• ESD performance
• Frequency division
• Shift registers
• Frequency Dividers