SN74LVTH374DWE4 Overview
The flip flop is packaged in a case of SOIC. It is configured with TTLas an output. Terminations are 20. The power source is powered by 3.3V. Electronic devices of this type belong to the LVTfamily. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. Due to its reliability, this T flip flop is well suited for TUBE. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 3.3V. To operate, the chip has a total of 3 output lines. This input has 1lines in it. It is set to -32mAfor the high level output current. It is set to 64mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 2.7VV as its minimum supply voltage. It supports a maximum supply voltage of 3.6V volts. This frequency can be achieved 150MHz. In this case, it uses a BUS DRIVER logic IC. It is equipped with 1 functions . The D latch is equipped with 20 pins. As a result of its output current of 64mA, it is very flexible in terms of design.
SN74LVTH374DWE4 Features
20 pins
8 Bits
1 Functions
20 pin count
SN74LVTH374DWE4 Applications
There are a lot of Texas Instruments
SN74LVTH374DWE4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
