TS12A44514PWR Overview

Presented in 14-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Operating temperature extended to -40°C~85°C TA. In total, there have been 14 terminations. By its 4 channels, the electronic component provides high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. It is injected into the electrical part body with 14 pins. The analog switch ics are built using SPST - NO switching circuits. Try searching for the analog switch ic with TS12A44514 if you are looking for variants. Analog switches have 20Ohm internal resistance. You can find the functions of the 14 pins in the datasheets. This switch device is a typical Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 12V to the switch device in normal circumstances. Single supply type digital switch with a low cost. 2V is the lowest voltage that should be fed to the electronic electronic part. The analogue multiplexer could operate on 50nA current. A voltage of 2.7V~12V is required to drain this analog switch from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 50nA. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. In order to operate the 4 inputs, there are several steps to follow. 530MHz-bandwidths can be used to transfer data between multiplexers. The Drain to Source resistance of this electronic component is 10Ohm.

TS12A44514PWR Features

4 Channels
Switch Circuit: SPST - NO
50nA Supply Current
Bandwidth: 530MHz
Drain-to-Source resistance: 10Ohm

TS12A44514PWR Applications

There are a lot of Texas Instruments TS12A44514PWR Analog Switches & Multiplexers ICs applications.

• Microprocessor controlled systems
• High-Voltage
• Routers
• Intelligent PBX
• PCMCIA cards
• Audio signal routing
• FTTH
• Sample hold systems
• Multi-Line E1 Interface Cards
• PBXs