Due to its 16-SSOP (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 4:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. Total terminations are 16. This electronic part offers high-quality output due to its 4 channels. An 2.5V voltage supply should allow the electrical part to be turned on and run. As part of its design, the 16 series is equipped with this electronic component. The analog switch ics are built using SP4T switching circuits. There are 2 circuits in this switch device. Search with TS3A5017 if you are looking for analog multiplexer variants. There is 12Ohm internal resistance in this digital multiplexer. To find out what the 16 pins do, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. A voltage higher than 3.6V should not normally be supplied to the switches. Digital switch that provides Single power at a cost-effective price. It is recommended to use 2.3V as the lowest voltage for the electrical part. 2.5μA current would be enough for this multiplexer to operate. Draining from a single voltage supply, this analog switch requires a voltage of 2.3V~3.6V. Putting voltage greater than 7μA on the multiplexer may cause damage. There are 165MHz bandwidths for data transfer. The analogue multiplexer has 8 outputs.
TS3A5017DBQR Features
4 Channels Switch Circuit: SP4T 2.5μA Supply Current Bandwidth: 165MHz
TS3A5017DBQR Applications
There are a lot of Texas Instruments TS3A5017DBQR Analog Switches & Multiplexers ICs applications.
Communication systems
Voice over IP/DSL – Integrated Access Devices, Smart