TS5A23157DGSR Overview

The electrical component comes in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 10 terminations have occurred. A electrical component with 2 channels is capable of high-quality output. When the electronic component is given a voltage of 1.8V, it should be turned on and run. Into the electrical component body are injected 10 pins. On the other hand, analog switches can be constructed using SPDT switching circuits. Look for analog switch ic variants by searching with TS5A23157. A 10Ohm internal resistance characterizes this multiplexer. The datasheets for the 10 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. A analog switch ic that has a cost-effective Single supply type. It is recommended to use 1.8V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1μA current. Analogue multiplexers require a 1.65V~5.5V voltage to drain from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to transfer data over a 220MHz-bandwidth. You shouldn't miss the additional features of the electrical component, such as: VIDEO APPLICATION. This digital multiplexer has 4 outputs.

TS5A23157DGSR Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
Bandwidth: 220MHz
Additional Features: VIDEO APPLICATION

TS5A23157DGSR Applications

There are a lot of Texas Instruments
TS5A23157DGSR Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)