TS5A23166DCURE4 Overview

Due to its 8-VFSOP (0.091, 2.30mm Width) packaging, the electronic part is convenient for international shipping. High reliability is achieved by using advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~85°C TA. In total, there are 8 terminations. High-quality output is provided by the electronic component's 1 channels. When the electronic component is given a voltage of 1.8V, it should be turned on and run. This electronic part can be found in the 8 series. Multiplexers built on a SPST - NO switching circuit are built. Try searching for the analog switch ic with TS5A23166 if you are looking for variants. The internal resistance of this digital multiplexer is 1Ohm. The datasheets for the 8 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage the electrical component should receive. In order to operate this switch device, it would need a current of 10nA. Analogue multiplexers require a 1.65V~5.5V voltage to drain from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 100nA. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. Operating 2 inputs is required. A 150MHz-bandwidth can be used for data transfer.

TS5A23166DCURE4 Features

1 Channels
Switch Circuit: SPST - NO
10nA Supply Current
Bandwidth: 150MHz

TS5A23166DCURE4 Applications

There are a lot of Texas Instruments TS5A23166DCURE4 Analog Switches & Multiplexers ICs applications.

• Fiber In The Loop (FITL)
• Precision data acquisition
• Microprocessor controlled systems
• Fiber to the Home
• Microwave transmission systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• E1 Multiplexer
• Video signal routing
• PBX interfaces
• Microprocessor Controlled Analog Systems