The electronic part can be shipped overseas conveniently because it is packaged in 6-TSSOP, SC-88, SOT-363. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 2:1. Increasing operating temperature to around -40°C~85°C TA. A total of 6 terminations have been recorded. A 1 channel electronic part produces high-quality output. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. There are 6 pins injected into the electronic part body. A SPDT switching circuit is used for these analog switches. This multiplexer is composed of 1 circuits. Try searching with TS5A3159 to find analog multiplexer variants. This digital multiplexer has 1.1Ohm internal resistance. For details about the functions of 6 pins, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. An effective Single supply digital multiplexer. A low voltage of 1.65V should be applied to the electronic component. For this multiplexer to operate, 100nA current would be sufficient. Using a single voltage supply, this switch device consumes 1.65V~5.5V volts. The analogue multiplexer may be damaged if voltage is greater than 100nA. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. This switch operates within the bandwidth of 100MHz. Don't forget the additional features of this electronic part, such as: 2-CHANNEL MUX/DEMUX.