74HC174D Overview

It is packaged in the way of 16-SOIC (0.154, 3.90mm Width). As part of the package Cut Tape (CT), it is embedded. This output is configured with Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. With a supply voltage of 2V~6V volts, it operates. In this case, the operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop is a part of the 74HCseries of FPGAs. In order for it to function properly, its output frequency should not exceed 71MHz. In total, it contains 1 elements. T flip flop consumes 4μA quiescent energy. Input capacitance of this device is 5pF farads.

74HC174D Features

Cut Tape (CT) package
74HC series

74HC174D Applications

There are a lot of Toshiba Semiconductor and Storage 74HC174D Flip Flops applications.

• Bus hold
• Load Control
• Test & Measurement
• Divide a clock signal by 2 or 4
• Reduced system switching noise
• Single Up Count-Control Line
• Storage Registers
• Data storage
• Latch
• Guaranteed simultaneous switching noise level