DG211BDY-T1-E3 Overview

The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with DG211. A 160Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 25V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 4.5V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 10μA current. A voltage higher than 10μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VFor dual power supplies, a voltage of at least 4.5V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. Among the inputs that can be operated are the 4 inputs. There is 45Ohm Drain to Source resistance on this electronic part.

DG211BDY-T1-E3 Features

1 Channels
Switch Circuit: SPST - NC
10μA Supply Current
Drain-to-Source resistance: 45Ohm

DG211BDY-T1-E3 Applications

There are a lot of Vishay Siliconix
DG211BDY-T1-E3 Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)