DG2738DN-T1-E4 Overview

As the electronic part is packed in 8-UFQFN, international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. Operational temperature extended around -40°C~85°C TA. Totally, there are 8 terminations. Due to its 1 channels, the electrical component produces high-quality output. With a 3V voltage supply, the electrical component should be turned on and run. It is injected into the electrical part body with 8 pins. Multiplexers built on a SPST - NC switching circuit are built. The multiplexer consists of 2 circuits. DG2738 can be used to search for analog multiplexer variants. This digital multiplexer has 8Ohm internal resistance. Datasheets for 8 pin functions are available upon request. Multiplexer or Switches is a typical switch device. Users should never supply a voltage higher than 4.3V to a switch device. An effective Single supply digital multiplexer. A low voltage of 2.3V should be applied to the electronic component. 1μA current would be enough for this multiplexer to operate. A voltage of 2.3V~4.3V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. The digital multiplexer has SEPARATE OUTPUT outputs that can be used.

DG2738DN-T1-E4 Features

1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
-3db Bandwidth: 720MHz

DG2738DN-T1-E4 Applications

There are a lot of Vishay Siliconix DG2738DN-T1-E4 Analog Switches & Multiplexers ICs applications.

• Switching Systems
• Digital cross connects (DSX-1)
• Avionics
• SONET/SDH ADM
• Audio and video routing
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• SONET
• Signal routing between systems
• Remote Powered Equipment
• Data switching