DG409DY-T1 Overview

Shipping overseas is convenient due to the electrical component's packing in 16-SOIC (0.154, 3.90mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. 4:1 is the ratio between multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. 16 terminations have been made so far. High-quality output is provided by the electronic component's 4 channels. A 15V voltage supply should turn on and run the electronic component. It is injected into the electrical part body with 16 pins. Multiplexers built on a SP4T switching circuit are built. A 2 circuit is present in this switch device. Internally, this switch multiplexer has a resistance of 100Ohm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. Dual, Single supply type digital switch with a low cost. 5V should be the lowest voltage fed to the electronic component. It may damage the digital multiplexer if the voltage is higher than 500μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 20V. When using dual power supplies, you should attach at least 5V. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board. Operating the 8 inputs requires 8 inputs.

DG409DY-T1 Features

4 Channels
Switch Circuit: SP4T

DG409DY-T1 Applications

There are a lot of Vishay Siliconix DG409DY-T1 Analog Switches & Multiplexers ICs applications.

• Fiber to the Home
• Digital Cross-Connects
• Automotive applications
• Ultrasound
• Intelligent PBX
• Audio signal routing
• Cellular phones
• Voice over IP/DSL – Integrated Access Devices, Smart
• SONET
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads