Presented in 16-SOIC (0.154, 3.90mm Width), this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 4:1. Around -40°C~85°C TA is the extended operating temperature. In total, 16 terminations have occurred. A electrical component with 4 channels is capable of high-quality output. In the case of a voltage supply of 15V volts, the electrical part can be powered up and run. A total of 16 pins are injected into the electrical part body. Based on SP4T switching circuits, these analog multiplexers work. Circuits number 2 make up this analogue multiplexer. If you are looking for variants of the digital switch, trying search with DG409. This digital multiplexer has 40Ohm internal resistance. You can find the functions of the 16 pins in the datasheets. In normalcircumstances, users should not exceed 36V volts for the multiplexer. Dual, Single supply type digital switch with a low cost. It is recommended that the electrical component receives a voltage of 5V. It would be sufficient to run this analogue multiplexer with 1μA current. Putting voltage greater than 500μA on the multiplexer may cause damage. Despite this switch's dual supply capability, its voltage should not exceed 20V. In the case of dual power supplies, you should connect at least 5V. Operating 8 inputs is required. Drain to Source resistance for this electronic component is 100Ohm.