DG413HSDY-T1-E3 Overview

This electronic part is conveniently packaged in 16-SOIC (0.154, 3.90mm Width), making it easy to ship abroad. This packaging method provides high reliability because it uses advanced packaging techniques. This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Extended operating temperature around -40°C~85°C TA. Total terminations are 16. High-quality output is provided by the electronic component's 1 channels. A 15V voltage supply should turn on and run the electronic component. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Try searching with DG413 if you're looking for variants. The internal resistance of this digital multiplexer is 80Ohm. The datasheets for the 16 pins explain the functions. A analogue multiplexer of this type is a Multiplexer or Switches. normally, users should not supply switches with voltages higher than 44V. A analog switch ic that has a cost-effective Dual, Single supply type. In order for the electronic part to function properly, the lowest voltage should be 13V. In order to operate this switch device, it would need a current of 1μA. A voltage higher than 1μA may cause damage to the switch multiplexer. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. In the case of dual power supplies, you should connect at least 7V. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A 4 input needs to be operated.

DG413HSDY-T1-E3 Features

1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current

DG413HSDY-T1-E3 Applications

There are a lot of Vishay Siliconix DG413HSDY-T1-E3 Analog Switches & Multiplexers ICs applications.

• Precision test equipment
• Data Acquisition Systems
• SDH
• Cable Modem
• Ultrasound
• Medical systems
• Private Branch Exchange (PBX)
• Medical Instrumentation
• Relay Replacement
• Existing multiplexer applications (both fault-protected and nonfault-protected)