As the electronic part is packed in 8-SOIC (0.154, 3.90mm Width), international shipping is convenient. In order to provide high reliability, an advanced packaging method Tube is used. In Surface Mount, you'll find this switch device. Multiplexer and demultiplexer circuits have a number 2:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there have been 8 terminations. Due to its 1 channels, the electrical component produces high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. An electrical component of this type can be found in the 8 series. A SPDT switching circuit is used for these analog switches. Try searching for DG419 variants of the analog switch ic. As far as internal resistance is concerned, it has 35Ohm. Datasheets for 8 pin functions are available upon request. A analogue multiplexer of this type is a Multiplexer or Switches. A voltage higher than 44V should not normally be supplied to the switches. An effective Dual, Single supply digital multiplexer. 13V is the lowest voltage the electrical component should receive. In order to operate this switch device, it would need a current of 1nA. It may damage the digital multiplexer if the voltage is higher than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. When using dual power supplies, you should attach at least 7V. Operating voltages of 15V are compatible with the electrical part. The 1 inputs need to be operated in order to work. Resistivity from Drain to Source is 20Ohm for this electronic part. In this digital multiplexer, there are 2 outputs.