The electronic part can be shipped overseas conveniently because it is packaged in 16-DIP (0.300, 7.62mm). This packaging method provides high reliability because it uses advanced packaging techniques. In Through Hole, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. In total, there have been 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. A 15V voltage supply should turn on and run the electronic component. An electrical component of this type can be found in the 16 series. These analog multiplexers are built based on SPST - NC switching circuits. Use DG441 to search for variants of the digital switches. As far as internal resistance is concerned, it has 85Ohm. Datasheets for functions of 16 pins are available. It is a typical Multiplexer or Switches analog multiplexer. It is normally recommended that users do not supply the multiplexer with voltages higher than 36V. Dual, Single supply type digital switch with a low cost. There should be 13V voltage fed to the electrical part below 13V. This multiplexer would work with 15μA current. A voltage higher than 100μA may cause damage to the switch multiplexer. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 22V. In the case of dual power supplies, you should connect at least 7V. Among the inputs that can be operated are the 4 inputs. A Drain to Source resistance of 85Ohm is shown for this electronic part.