ADG211AKR Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). The advanced packaging method Tube provides high reliability. This analog switch is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 16. A 4 channel electronic part produces high-quality output. If the voltage supply is 15V volts, the electrical component should be turned on and run. There are 16 pins injected into the electronic part body. The analog switch ics are built using SPST - NC switching circuits. Try searching for the analog switch ic with ADG211 if you are looking for variants. It has an internal resistance of 115Ohm. To find out what the 16 pins do, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 25V. Analog switch ics with Dual supply type are cost-effective. If you put voltage higher than 1mA on the digital multiplexer, damage may occur. Despite this switch device's dual supply capability, its voltage should not exceed 22V. 5V operating voltages can be used with this electrical part.

ADG211AKR Features

4 Channels
Switch Circuit: SPST - NC

ADG211AKR Applications

There are a lot of Analog Devices Inc. ADG211AKR Analog Switches & Multiplexers ICs applications.

• Industrial and process control systems
• Avionics
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Voice over IP/DSL – Integrated Access Devices, Smart
• Switching Systems
• PDH Multiplexers
• PCMCIA cards
• Low-Voltage
• Industrial
• SDH