Shipping overseas is convenient with the electronic component packed in 20-TSSOP (0.173, 4.40mm Width). In order to provide high reliability, an advanced packaging method Tube is used. In Surface Mount, you'll find this switch device. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Operational temperature extended around -40°C~125°C TA. Total terminations are 20. High-quality output is provided by the electronic component's 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. There is an electrical component included in the 20 series. Circuits based on SPDT switching are used to construct these analog switch ics. Look for analog switch ic variants by searching with ADG5434. As far as internal resistance is concerned, it has 14Ohm. For functions related to 20 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. Multiplexers should not be powered above 40V in normal situations. A analog switch ic that has a cost-effective Dual, Single supply type. 9V should be the lowest voltage fed to the electronic component. A voltage higher than 55μA may cause damage to the switch multiplexer. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. The voltage should be at least 9V if you are using dual power supplies. Operating the 4 inputs requires 4 inputs. 140MHz-bandwidths can be used to transfer data between multiplexers. There is 14Ohm Drain to Source resistance on this electronic part. The analog switch ics has 8 outputs.