As the electronic part is packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width), international shipping is convenient. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature around -40°C~85°C TA extended. A total of 10 terminations have been recorded. A 2 channel electronic part produces high-quality output. With a 5V voltage supply, the electrical component should be turned on and run. The electrical component body receives 10 pins. Multiplexers built on a SPST - NC switching circuit are built. Try searching with ADG622 to find analog multiplexer variants. An switch multiplexer with 5.5Ohm internal resistance has a value of 5.5Ohm. To find out what the functions of 10 pins are, please refer to their datasheets. Theswitch device is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. 2.7V should be the lowest voltage fed to the electronic component. There is no problem with using dual supply voltage, but it should not exceed 5.5V. A dual power supply should have at least 2.7V voltage attached. The digital multiplexer has SEPARATE OUTPUT outputs that can be used.