As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~125°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 1 channels. Powered by a 5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPDT switching are used to construct these analog switch ics. Try searching with ADG633 to find analog multiplexer variants. An switch multiplexer with 75Ohm internal resistance has a value of 75Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 12V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2V. An operating current of 10nA would be sufficient for this switch device. When the digital multiplexer is charged above 1μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 6V. It is recommended that you attach at least 2V to your dual power supply. Operating the 3 inputs requires 3 inputs. There are 580MHz bandwidths for data transfer. A analog switch ics with 6 outputs is included. It conducts in a 1-bit manner.