Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tape & Reel (TR) provides high reliability. Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Around -40°C~85°C TA is the extended operating temperature. Total terminations are 16. As a result of its 4 channels, this electronic component provides high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the electrical part body. The analog switch ics are built using SPST - NO/NC switching circuits. Try searching with ADG713 to find analog multiplexer variants. The internal resistance of this digital multiplexer is 4Ohm. You can find the functions of the 16 pins in the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. There should be 1.8V voltage fed to the electrical part below 1.8V. An operating current of 1nA would be sufficient for this switch device. Draining from a single voltage supply, this analog switch requires a voltage of 1.8V~5.5V. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. In 200MHz-bandwidths, data can be transferred. Don't miss this electronic component's additional features, such as: CAN ALSO OPERATE WITH 5 V SUPPLY.
ADG713BRZ-REEL Features
4 Channels Switch Circuit: SPST - NO/NC 1nA Supply Current Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
ADG713BRZ-REEL Applications
There are a lot of Analog Devices Inc. ADG713BRZ-REEL Analog Switches & Multiplexers ICs applications.