The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 8 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. Into the electrical component body are injected 8 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with ADG702. A 3Ohm internal resistance characterizes this multiplexer. The datasheets for the 8 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. It is recommended to use 1.8V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1nA current. Analogue multiplexers require a 1.8V~5V voltage to drain from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to transfer data over a 200MHz-bandwidth. There is 3Ohm Drain to Source resistance on this electronic part.