Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. Operational temperature extended around -40°C~85°C TA. Total terminations are 16. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 3V volts, the electrical component should be turned on and run. Into the electrical component body are injected 16 pins. SPST - NO/NC switching circuits are used in these analog switch ics. If you are looking for variants of the digital switch, trying search with ADG713. The internal resistance of this digital multiplexer is 4Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. An effective Single supply digital multiplexer. It is recommended that the electrical component receives a voltage of 1.8V. 1nA current would be enough for this multiplexer to operate. The voltage required by this switch device is 1.8V~5.5V, draining from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. There is also CAN ALSO OPERATE WITH 5 V SUPPLY to look out for in this electronic part.
ADG713BRU-REEL Features
4 Channels Switch Circuit: SPST - NO/NC 1nA Supply Current -3db Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
ADG713BRU-REEL Applications
There are a lot of Analog Devices Inc. ADG713BRU-REEL Analog Switches & Multiplexers ICs applications.
Cable PC
Central office
Mechanical reed relay replacement
Medical Instrumentation
Communication systems
Audio and video signal routing
Voice over IP/DSL – Integrated Access Devices, Smart