The electrical component comes in 20-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tube. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a number of circuits 2:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. Total terminations are 20. A 4 channel electronic part produces high-quality output. Turning on and running the electrical part should be easy with a 2.5V voltage supply. This electrical component is included in the 20 series of products. A SPDT switching circuit is used to build these analog multiplexers. Try searching with ADG734 to find analog multiplexer variants. There is 4.5Ohm internal resistance in this digital multiplexer. For functions related to 20 pins, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Analog switch ics with Dual, Single supply type are cost-effective. A low voltage of 1.8V should be applied to the electronic component. The switch device would be able to operate with 1nA current. The analogue multiplexer may be damaged if voltage is greater than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 2.75V. If you are using a dual power supply, you should attach at least 2.25V. It is possible to transfer data over a 160MHz-bandwidth. The analogue multiplexer has 8 outputs.