As the electronic part is packed in 16-DIP (0.300, 7.62mm), international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tube. Through Hole is where this multiplexer is located. Multiplexers and demultiplexers have a number of circuits 1:1. Operating temperature extended to 0°C~70°C TA. A total of 16 terminations have been recorded. This electronic part offers high-quality output due to its 1 channels. When the electronic component is given a voltage of 15V, it should be turned on and run. It is part of the design of the 16 series that this electronic component is included. Circuits based on SPST - NC switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with MAX312 if you're looking for variants. It has an internal resistance of 10Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Multiplexers should not be powered above 30V in normal situations. An effective Dual, Single supply digital multiplexer. 4.5V is the lowest voltage the electrical component should receive. A voltage higher than 1μA may cause damage to the switch multiplexer. Despite this switch's dual supply capability, its voltage should not exceed 20V. A dual power supply should have at least 4.5V voltage attached. This analog switch ic utilizes SEPARATE OUTPUT output. It can operate from 18V operating voltages. There is 10Ohm resistance between the Drain and Source on this part.