MAX4648EUT+T Overview

The electrical component comes in SOT-23-6 packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 6 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 6 pins. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Circuits number 1 make up this analogue multiplexer. Look for analog switch ic variants by searching with MAX4648. A 25Ohm internal resistance characterizes this multiplexer. The datasheets for the 6 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 9V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1μA current. A voltage higher than 100μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 20VFor dual power supplies, a voltage of at least 4.5V should be attached. This electrical part is compatible with 15V operating voltages. There is 25Ohm Drain to Source resistance on this electronic part. 2-bit operation is possible.

MAX4648EUT+T Features

1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
Drain-to-Source resistance: 25Ohm
2-Bit

MAX4648EUT+T Applications

There are a lot of Maxim Integrated
MAX4648EUT+T Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)