74AHC377D-Q100J Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. The output it is configured with uses Non-Inverted. This trigger is configured to use Positive Edge. The electronic part is mounted in the way of Surface Mount. Powered by a 2V~5.5Vvolt supply, it operates as follows. In this case, the operating temperature is -40°C~125°C TA. This D latch has the type D-Type. FPGAs belonging to the Automotive, AEC-Q100, 74AHCseries contain this type of chip. Its output frequency should not exceed 120MHz. D latch consists of 1 elements. T flip flop consumes 4μA quiescent energy. A JK flip flop with a 3pFfarad input capacitance is used here. This electronic part is mounted in the way of Surface Mount. This device exhibits a clock edge trigger type of Positive Edge. High efficiency requires the supply voltage to be maintained at 5V. It consumes 4μA of quiescent current without being affected by external factors. The high level output current is set to 8mA. There is 8mA output current at the low level. The operating temperature should be lower than 125°C. In order for the system to operate properly, the temperature should be higher than -40°C. The system operates with a minimum supply voltage of 2V. There is a maximum voltage support of 5.5V. It is possible to achieve 120MHz frequencies.

74AHC377D-Q100J Features

Tape & Reel (TR) package
Automotive, AEC-Q100, 74AHC series

74AHC377D-Q100J Applications

There are a lot of Nexperia USA Inc. 74AHC377D-Q100J Flip Flops applications.

• Storage Registers
• ATE
• Cold spare funcion
• High Performance Logic for test systems
• Memory
• Frequency Divider circuits
• Functionally equivalent to the MC10/100EL29
• Divide a clock signal by 2 or 4
• ESD performance
• Matched Rise and Fall