74AHCT74D-Q100J Overview

The flip flop is packaged in a case of 14-SOIC (0.154, 3.90mm Width). D flip flop is included in the Tape & Reel (TR)package. The output it is configured with uses Differential. It is configured with a trigger that uses a value of Positive Edge. There is an electronic component mounted in the way of Surface Mount. It operates with a supply voltage of 4.5V~5.5V. -40°C~125°C TAis the operating temperature. This logic flip flop is classified as type D-Type. In this case, it is a type of FPGA belonging to the 74AHCT series. Its output frequency should not exceed 140MHz. D latch consists of 2 elements. T flip flop consumes 2μA quiescent energy. JK flip flop belongs to 74AHCT74 family. The input capacitance of this JK flip flopis 3pF farads. It is mounted in the way of Surface Mount. Basically, it is designed with a set of 14 pins. This device has Positive Edgeas its clock edge trigger type. The flip flop is designed with 2bits. In order to ensure high efficiency, the supply voltage should remain at 5V. This D latch consumes 2μA quiescent current at all. A -8mAvalue is set for the high level output current. There is no low level output current set at 8mA. If the operating temperature is lower than 125°C, it is recommended. The operating temperature should be higher than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. A maximum voltage of 5.5V can be provided by it.

74AHCT74D-Q100J Features

Tape & Reel (TR) package
74AHCT series
14 pins
2 Bits

74AHCT74D-Q100J Applications

There are a lot of Nexperia USA Inc. 74AHCT74D-Q100J Flip Flops applications.

• EMI reduction circuitry
• Frequency Divider circuits
• Test & Measurement
• Patented noise
• Differential Individual
• Storage Registers
• Reduced system switching noise
• Common Clocks
• Frequency division
• Control circuits