74AC377MTCX Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Tape & Reel (TR) package. Non-Invertedis the output configured for it. This trigger uses the value Positive Edge. There is an electronic component mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. It is operating at a temperature of -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74ACseries FPGA. In order for it to function properly, its output frequency should not exceed 175MHz. The element count is 1 . There is a consumption of 40μAof quiescent energy. The 74AC377family includes it. There is 4.5pF input capacitance for this T flip flop. There is an electronic component mounted in the way of Surface Mount. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. 8bits are used in its design. The superior flexibility is achieved through the use of 8 circuits. There are 8 output lines in this JK flip flop. This input has 1lines in it. A -24mAis set for the high level output current. 24mA is the low level output current. Operating temperatures should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. It operates with the minimal supply voltage of 2V. A maximum voltage of 6V can be provided by it. It is possible to achieve 175MHz frequencies.

74AC377MTCX Features

Tape & Reel (TR) package
74AC series
20 pins
8 Bits

74AC377MTCX Applications

There are a lot of ON Semiconductor 74AC377MTCX Flip Flops applications.

• Dynamic threshold performance
• Event Detectors
• Consumer
• Latch-up performance
• Data storage
• Buffer registers
• Data transfer
• Safety Clamp
• Bus hold
• ESCC