MC10EP51DR2G Overview

The flip flop is packaged in 8-SOIC (0.154, 3.90mm Width). It is contained within the Tape & Reel (TR)package. Differentialis the output configured for it. It is configured with the trigger Positive, Negative. Surface Mountmounts this electrical part. The supply voltage is set to -3V~-5.5V. Temperature is set to -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. FPGAs belonging to the 10EPseries contain this type of chip. Its output frequency should not exceed 3GHz Hz. It consumes 45mA of quiescent 8terminations have occurred. The 10EP51family includes it. The D flip flop is powered by a voltage of 3.3V . It is a member of the 10Efamily of D flip flop. In this case, the electronic component is mounted in the way of Surface Mount. There are 8pins on it. This device has Positive Edgeas its clock edge trigger type. The part you are looking for is included in FF/Latches. An electronic part designed with 1bits is used in this application. The maximal supply voltage (Vsup) reaches 5.5V. The supply voltage (Vsup) should be kept above 3V for normal operation. Due to its superior flexibility, it uses 1 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. In order for the device to operate, it requires -5.2V power supplies. Additionally, you may refer to the D latch's additional NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. There is -50mA output current at the high level. There is 50mA output current at the low level.

MC10EP51DR2G Features

Tape & Reel (TR) package
10EP series
8 pins
1 Bits
-5.2V power supplies

MC10EP51DR2G Applications

There are a lot of ON Semiconductor MC10EP51DR2G Flip Flops applications.

• Balanced Propagation Delays
• Count Modes
• Latch
• Computing
• Memory
• Reduced system switching noise
• Test & Measurement
• Asynchronous counter
• ESD protection
• Shift registers