M74HCT374B1R Overview

It is embeded in 20-DIP (0.300, 7.62mm) case. The Tubepackage contains it. As configured, the output uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electrical part that is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis required for its operation. It is operating at -55°C~125°C TA. A flip flop of this type is classified as a D-Type. The 74HCTseries comprises this type of FPGA. There should be no greater frequency than 50MHzon its output. D latch consists of 1 elements. It consumes 4μA of quiescent In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. This D latch belongs to the family of 74HCT374. The power supply voltage is 5V. Its input capacitance is 5pFfarads. An electronic device belonging to the family HCTcan be found here. The electronic part is mounted in the way of Through Hole. This board has 20 pins. Its clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. There are 8bits in its design. Its superior flexibility is attributed to its use of 8 circuits. The D latch operates on 5V volts. This flip flop has a total of 2ports. The supply voltage should be maintained at 5V for high efficiency. There are no output lines on the JK flip flop.

M74HCT374B1R Features

Tube package
74HCT series
20 pins
8 Bits
5V power supplies

M74HCT374B1R Applications

There are a lot of STMicroelectronics M74HCT374B1R Flip Flops applications.

• Safety Clamp
• Balanced Propagation Delays
• Single Up Count-Control Line
• Control circuits
• CMOS Process
• Registers
• Cold spare funcion
• ESD performance
• Differential Individual
• Single Down Count-Control Line