CD74HC377M96G4 Overview
The flip flop is packaged in SOIC. In total, there are 1 elements. Currently, there are 20 terminations. The D flip flop is powered by a voltage of 5V . Devices in the HC/UHfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. In terms of quiescent current, it consumes 8μA . Additionally, you may refer to the D latch's additional WITH HOLD MODE. -5.2mA is set as the high level output current. In the low level output current setting, 5.2mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -55°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 6V. It is possible to achieve 60MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 1 functions are available on the T flip flop. There are 20 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 5.2mA.
CD74HC377M96G4 Features
20 pins
1 Functions
20 pin count
CD74HC377M96G4 Applications
There are a lot of Texas Instruments
CD74HC377M96G4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
