SN74AHCT574DW Overview

20-SOIC (0.295, 7.50mm Width)is the packaging method. D flip flop is included in the Tubepackage. As configured, the output uses Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountmounts this electrical part. The supply voltage is set to 4.5V~5.5V. Temperature is set to -40°C~85°C TA. A flip flop of this type is classified as a D-Type. It is a type of FPGA belonging to the 74AHCT series. There should be no greater frequency than 115MHzon its output. A total of 1elements are contained within it. There is a consumption of 4μAof quiescent energy. It has been determined that there have been 20 terminations. D latch belongs to the 74AHCT574 family. A voltage of 5V provides power to the D latch. Input capacitance of this device is 3pF farads. It is a member of the AHCT/VHCT/VTfamily of D flip flop. Electronic part Surface Mountis mounted in the way. The 20pins are designed into the board. This device has Positive Edgeas its clock edge trigger type. This device is part of the Bus Driver/Transceiverbase part number family. Flip flops designed with 8bits are used in this part. There are 5V power supplies attached to it. The D flip flop has no ports embedded. The supply voltage should be maintained at 5V for high efficiency. With an output current of 8mA, this device offers maximum design flexibility. Currently, there are 3 lines of input. 8 channels are available.

SN74AHCT574DW Features

Tube package
74AHCT series
20 pins
8 Bits
5V power supplies

SN74AHCT574DW Applications

There are a lot of Texas Instruments SN74AHCT574DW Flip Flops applications.

• Reduced system switching noise
• Digital electronics systems
• Patented noise
• Shift Registers
• Asynchronous counter
• Bus hold
• Computers
• Guaranteed simultaneous switching noise level
• Dynamic threshold performance
• Frequency division