SN74ALS374ADBRG4 Overview

The item is packaged in 20-SSOP (0.209, 5.30mm Width)cases. D flip flop is embedded in the Tape & Reel (TR) package. There is a Tri-State, Non-Invertedoutput configured with it. This trigger uses the value Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. The operating temperature is 0°C~70°C TA. D-Typedescribes this flip flop. JK flip flop belongs to the 74ALSseries of FPGAs. A frequency of 35MHzshould not be exceeded by its output. The element count is 1 . As a result, it consumes 19mA of quiescent current without being affected by external factors. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. If you search by 74ALS374, you will find similar parts. It is powered by a voltage of 5V . It belongs to the family of electronic devices known as ALS. A part of the electronic system is mounted in the way of Surface Mount. This board has 20 pins. This device's clock edge trigger type is Positive Edge. This part is included in FF/Latches. There are 8bits in its design. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. There are 5V power supplies attached to it. This D flip flop is equipped with 0 ports. For high efficiency, the supply voltage should be set to 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. As of now, there are 8input lines.

SN74ALS374ADBRG4 Features

Tape & Reel (TR) package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS374ADBRG4 Applications

There are a lot of Texas Instruments SN74ALS374ADBRG4 Flip Flops applications.

• Shift Registers
• Functionally equivalent to the MC10/100EL29
• Load Control
• ESCC
• Divide a clock signal by 2 or 4
• Bounce elimination switch
• Set-reset capability
• Matched Rise and Fall
• Registers
• Synchronous counter