SN74ALS534ADWR Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. It is contained within the Cut Tape (CT)package. As configured, the output uses Tri-State, Inverted. There is a trigger configured with Positive Edge. Surface Mountis in the way of this electric part. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. A temperature of 0°C~70°C TAis used in the operation. It belongs to the type D-Typeof flip flops. In terms of FPGAs, it belongs to the 74ALS series. It should not exceed 35MHzin terms of its output frequency. The list contains 1 elements. As a result, it consumes 19mA of quiescent current without being affected by external factors. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is a member of the 74ALS534 family. A voltage of 5V is used as the power supply for this D latch. It is a member of the ALSfamily of D flip flop. It is mounted by the way of Surface Mount. This board is designed with 20pins on it. Its clock edge trigger type is Positive Edge. The RS flip flops belongs to Bus Driver/Transceiver base part number. An electronic part with 8bits has been designed. Using 8 circuits, it is highly flexible. In view of its reliability, this D flip flop is a good fit for TR. The system runs on a power supply of 5V watts. The flip flop contains 2ports. For high efficiency, the supply voltage should be set to 5V. As a result of its output current of 24mA, it is very flexible in terms of design. This input has 3lines in it.

SN74ALS534ADWR Features

Cut Tape (CT) package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS534ADWR Applications

There are a lot of Texas Instruments SN74ALS534ADWR Flip Flops applications.

• ESCC
• Clock pulse
• Load Control
• ATE
• Single Up Count-Control Line
• ESD performance
• Frequency division
• Common Clocks
• Dynamic threshold performance
• Storage Registers