SN74ALS575ADWR Overview
The flip flop is packaged in a case of 24-SOIC (0.295, 7.50mm Width). You can find it in the Tape & Reel (TR)package. This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. The electronic part is mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is operating at a temperature of 0°C~70°C TA. A flip flop of this type is classified as a D-Type. The FPGA belongs to the 74ALS series. It should not exceed 30MHzin its output frequency. The list contains 1 elements. There is a consumption of 17mAof quiescent energy. It has been determined that there have been 24 terminations. JK flip flop belongs to 74ALS575 family. A voltage of 5V is used to power it. ALSis the family of this D flip flop. There is an electronic part mounted in the way of Surface Mount. As you can see from the design, it has pins with 24. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. 8bits are used in its design. Due to its superior flexibility, it uses 8 circuits. A total of 5V power supplies are needed to run it. The flip flop has 2ports embedded within it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. Its output current of 24mAallows for maximum design flexibility. This input has 4lines. WITH SYNCHRONOUS CLEARis also one of its characteristics.
SN74ALS575ADWR Features
Tape & Reel (TR) package
74ALS series
24 pins
8 Bits
5V power supplies
SN74ALS575ADWR Applications
There are a lot of Texas Instruments SN74ALS575ADWR Flip Flops applications.
- Automotive
- Bounce elimination switch
- Data Synchronizers
- Buffer registers
- Matched Rise and Fall
- Latch
- Convert a momentary switch to a toggle switch
- ESD protection
- Safety Clamp
- Control circuits
