SN74AUC2G66DCUR Overview

Shipping overseas is convenient with the electronic component packed in 8-VFSOP (0.091, 2.30mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operation at a temperature around -40°C~85°C TA. Total terminations are 8. The electronic part delivers high-quality output through its 2 channels. If the voltage supply is 1.1V volts, the electrical component should be turned on and run. It is injected into the electrical part body with 8 pins. These analog multiplexers are built based on SPST - NO switching circuits. Try searching for 74AUC2G66 variants of the analog switch ic. It has an internal resistance of 15Ohm. You can find the functions of the 8 pins in the datasheets. This switch device is a typical Multiplexer or Switches. A voltage higher than 2.7V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. In order for the electronic part to function properly, the lowest voltage should be 800mV. An operating current of 10μA would be sufficient for this switch device. Using only a single voltage supply, this analog switch requires 0.8V~2.7V voltage. A voltage higher than 10μA may cause damage to the switch multiplexer. This switch operates within the bandwidth of 500MHz.

SN74AUC2G66DCUR Features

2 Channels
Switch Circuit: SPST - NO
10μA Supply Current
-3db Bandwidth: 50MHz
Bandwidth: 500MHz

SN74AUC2G66DCUR Applications

There are a lot of Texas Instruments SN74AUC2G66DCUR Analog Switches & Multiplexers ICs applications.

• Channelized and Unchannelized DS3 applications
• Intelligent PBX
• Battery Powered Instruments
• Data Acquisition Systems
• SDH
• Modems
• Automatic test equipment
• Industrial control systems
• DSLAMs
• Multiplexers