SN74HC374ADBRE4 Overview

As a result, it is packaged as 20-SSOP (0.209, 5.30mm Width). There is an embedded version in the package Tape & Reel (TR). In the configuration, Tri-State, Non-Invertedis used as the output. There is a trigger configured with Positive Edge. Surface Mountis positioned in the way of this electronic part. The supply voltage is set to 2V~6V. In the operating environment, the temperature is -40°C~85°C TA. The type of this D latch is D-Type. JK flip flop is a part of the 74HCseries of FPGAs. There should be no greater frequency than 70MHzon its output. A total of 1elements are present in it. T flip flop consumes 8μA quiescent energy. The 74HC374 family contains this object. The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Electronic part Surface Mountis mounted in the way. A Positive Edgeclock edge trigger is used in this device.

SN74HC374ADBRE4 Features

Tape & Reel (TR) package
74HC series

SN74HC374ADBRE4 Applications

There are a lot of Texas Instruments SN74HC374ADBRE4 Flip Flops applications.

• Common Clocks
• Balanced Propagation Delays
• Buffered Clock
• Storage registers
• Power down protection
• Pattern generators
• Modulo – n – counter
• Guaranteed simultaneous switching noise level
• Event Detectors
• Divide a clock signal by 2 or 4