Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. The advanced packaging method Tape & Reel (TR) provides high reliability. A switch device like this is mounted in Surface Mount. 4:1 is the number of circuits in the multiplexer and demultiplexer. Around -40°C~85°C TA is the extended operating temperature. In total, 16 terminations have occurred. The electronic part provides high-quality output because it has 4 channels. A 2.5V voltage supply should turn on and run the electronic component. The electronic part body is injected with 16 pins. Based on SP4T switching circuits, these analog multiplexers work. 2 circuits are used in this analogue multiplexer. Try searching with TS3A5017 if you're looking for variants. This digital multiplexer has 12Ohm internal resistance. To find out what the 16 pins do, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 3.6V. The digital multiplexer has a low cost Single supply. It is recommended that the electrical component receives a voltage of 2.3V. An operating current of 2.5μA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 2.3V~3.6V volts. A digital multiplexer may suffer damage if voltage is applied above 7mA. 165MHz bandwidths enable data to be transferred. A analog switch ics with 8 outputs is included.
TS3A5017PWRG4 Features
4 Channels Switch Circuit: SP4T 2.5μA Supply Current Bandwidth: 165MHz
TS3A5017PWRG4 Applications
There are a lot of Texas Instruments TS3A5017PWRG4 Analog Switches & Multiplexers ICs applications.