The electrical component comes in 5-TSSOP, SC-70-5, SOT-353 packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. It is mounted in the position Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operation at a temperature around -40°C~85°C TA. High-quality output is provided by the electronic component's 1 channels. These analog multiplexers are built based on SPST - NC switching circuits. A total of 1 circuits make up this switch device. Try searching with TS5A3167 to find analog multiplexer variants. It has an internal resistance of 900mOhm. Datasheets for functions of 5 pins are available. Multiplexers should not be powered above 5.5V in normal situations. Digital switch that provides Single power at a cost-effective price. There should be 1.65V voltage fed to the electrical part below 1.65V. 10nA current would be enough for this multiplexer to operate. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. It may damage the digital multiplexer if the voltage is higher than 100nA. The electrical component supports 1 inputs. The data can be transferred over a wide range of bandwidths, called 200MHz bandwidths. A temperature above 85°C is not suitable for operation of the analogue multiplexer. Resistivity from Drain to Source is 900mOhm for this electronic part. A analog switch ics with 1 outputs is included. It is offered by suppliers in package SC-70-5. Its conductivity is 1-bit.