74AHC574PW,112 Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. You can find it in the Tubepackage. Currently, the output is configured to use Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountis occupied by this electronic component. The supply voltage is set to 2V~5.5V. It is at -40°C~125°C TAdegrees Celsius that the system is operating. It belongs to the type D-Typeof flip flops. FPGAs belonging to the 74AHCseries contain this type of chip. In order for it to function properly, its output frequency should not exceed 115MHz. A total of 1elements are contained within it. T flip flop consumes 4μA quiescent energy. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. JK flip flop belongs to 74AHC574 family. A voltage of 5V is used as the power supply for this D latch. This T flip flop has a capacitance of 3pF farads at the input. AHC/VHC/H/U/Vis the family of this D flip flop. A part of the electronic system is mounted in the way of Surface Mount. The 20pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. It is designed with a number of bits of 8. Normal operation requires a supply voltage (Vsup) above 2V. This D flip flop is equipped with 0 ports. For high efficiency, the supply voltage should be set to 5V. This input has 8lines. Additionally, you may refer to the additional BROADSIDE VERSION OF 374 of the electronic flip flop.

74AHC574PW,112 Features

Tube package
74AHC series
20 pins
8 Bits

74AHC574PW,112 Applications

There are a lot of Nexperia USA Inc. 74AHC574PW,112 Flip Flops applications.

• Divide a clock signal by 2 or 4
• Buffered Clock
• Convert a momentary switch to a toggle switch
• ESD performance
• Data storage
• Control circuits
• Storage Registers
• Communications
• Instrumentation
• ATE