74LVTH574D,118 Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). It is included in the package Tape & Reel (TR). There is a Tri-State, Non-Invertedoutput configured with it. It is configured with a trigger that uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. A 2.7V~3.6Vsupply voltage is required for it to operate. In the operating environment, the temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In this case, it is a type of FPGA belonging to the 74LVTH series. In order for it to function properly, its output frequency should not exceed 150MHz. In total, there are 1 elements. There is 190μA quiescent consumption. It has been determined that there have been 20 terminations. The 74LVTH574family includes it. Power is supplied from a voltage of 3.3V volts. Its input capacitance is 4pFfarads. This D flip flop belongs to the family of LVT. This part is included in FF/Latches. It reaches the maximum supply voltage (Vsup) at 3.6V. Keeping the supply voltage (Vsup) above 2.7V is necessary for normal operation. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. In order for the device to operate, it requires 3.3V power supplies. This flip flop has a total of 2ports.

74LVTH574D,118 Features

Tape & Reel (TR) package
74LVTH series
3.3V power supplies

74LVTH574D,118 Applications

There are a lot of NXP USA Inc. 74LVTH574D,118 Flip Flops applications.

• Latch-up performance
• Asynchronous counter
• Buffer registers
• Single Up Count-Control Line
• Load Control
• Set-reset capability
• Latch
• Event Detectors
• 2 – Bit synchronous counter
• ESCC